Removing the Print Head
To remove the print head from your printer:
- Completely unload materials from your printer. For more information, see Unload Plastic.
- Turn your printer off.
- Remove the thumbscrew connecting the Bowden Tube to the print head. Allow the tube to hang freely.
- Slide the white Axon cable clip away from the print head and the circuit board.
- Gently squeeze the tabs at the top and bottom of the Axon cable connector to release it from the board. Allow the cable to hang freely.
- Use a 2.5mm Allen wrench to loosen and remove the two bolts connecting the print head to the print head base.
- Carefully pull the print head off of the print head base.
Replacing the Print Head
To replace the print head on your printer:
- Carefully place the new print head onto the print head base. Be careful to align the pins on the print head base with the holes on the print head so that the pins are not damaged.
- Use a 2.5mm Allen wrench to tighten the two bolts that connect the print head to the print head base.
- Reconnect the Axon cable and the Axon cable clip.
Note: Be careful not to break the cable, clip, or board. Be sure the cable is secure. The clip will keep the cable from dragging on parts or becoming damaged.
- Replace the Bowden tube and tighten the thumb screw into the print head.
- Turn your printer on.
- Reload plastic into your printer.